665JZ Starrett Inspection Holder AGD Dial Indicator Set in Case

665JZ
Starrett Inspection Holder and Dial Indicators

This is the most versatile dial indicator holder
with an extremely stable base (A) that is
8-1/2″ (215mm) long x 2-1/4″ (57mm) wide
at the bottom . It can inspect workpieces on
the top surface of the ground base or within
a working area defined by the 8″ (200mm)
upright base post (B) and the 9-1/2″ (238mm)
long gage-holding rod (C) . The base post can
be conveniently located anywhere along the
8-1/2″ (215mm) T-slot in the base .
This tool can be held in a vise or by a bolt in
a machine T-slot coming up through one of
the two 3/8″ (9 .5mm) holes in the base and
fastening down on the top surface .
D . Swivel Post Snug 665D
Snug has a .375″ (9 .5mm) hole for the gage
holding rod and a .465″ (11 .8mm) hole for
the upright post . Also comes with the 665L
Reducing Bushing (J) that can reduce the
.465″ (11 .8mm) hole to 3/8″ (9 .5mm) .
E . Base Reference Guide 665E (Optional)
Guide is used to check parts or surfaces from
straight or angular surfaces by use of the
radiused guide stop . This fits into the T-slot in
the bottom of the base and is fastened at right
angles to the length . Push up to or slide along
a radius surface .
F . Square Keyway Guide 665F (Optional)
This guide can also be referenced from a
square edge, a T-slot or a keyway with at least
a 1/2″ (12 .7mm) width . Has square edges and
is fastened at right angles to the length . Push
up to or slide along a square edge .

Three very useful inspection combinations can
be made by removing the complete swivel
post snug and gage holding rod as follows:
G . Clamp 665G
Take the clamp and put the clamp post into
the snug and lock it . Now this combination
can be used to clamp the gage holding rod
and the indicator into hard-to-reach places
for inspecting jigs, fixtures, lining up work on
centers and machine tables .
The clamp has a 3″ (75mm) capacity and a
post with an approximately 5-3/4″ (145mm)
length . The clamp post is .464″ (11 .8mm)
diameter that fits into the regular swivel post
snug 665D .
Three other clamp post diameter options
available – 665G-3/8 is a 3/8″ (9 .5mm)
diameter clamp post that can be used in
the regular swivel post snug 665D with the
addition of the 665L reducing bushing . The
665G-5/16 (7 .9mm) and 665G-1/4 (6 .3mm)
can be used with other snugs to hold an
indicator .
H . Tool Post Holder 665H
Put one end of the offset arm into the swivel
post snug 665D (with the 665L reducing
bushing in it) . Then put this rectangular tool
post holder 665H onto the other arm . This
combination now allows for a good, tight
setup in lathe tool posts and other machine
setups .
I . Offset Arm 665G-1
Another very popular measuring combination
is to put the reducing bushing (which is
furnished) into the snug and then put one
leg of the offset arm into it . Now the tool can
be used in a 3/8″ (9 .5mm) chuck or collet to
sweep a large area .